MIL --- D TL --- 211F
INTERNATIO NAL MARITIME O RGANIZ ATIO N
International Maritime Dangerous G oods Code
(Application for copies should be addressed to the International Maritime O rganization, 101---104
Piccadilly, London, WIV OAE, England)
ASTM STANDARDS
B 527
--- Standard Test Method for Determination of Tap Density of Metallic
Powders and Compounds
D 92
--- Flash and Fire Points by Cleveland O pen Cup
D 97
--- Pour Point of Petroleum O ils
D 130
--- Detection of Copper Corrosion from Petroleum Products by the Copper
Strip Tarnish Test
D 445
--- Kinematic Viscosity of Transparent and O paque Liquids (and the
Calculation of Dynamic Viscosity)
D 974
--- Acid and Base Number by Color ---Indicator Titration
D 1193
--- Reagent Water
D 1500
--- ASTM Color of Petroleum Products (ASTM Color Scale)
--- Calculating Viscosity Index from Kinematic Viscosity at 40 and 100 _C
D 2270
C 117
--- Standard Test Method for Minerals Finer than 75-m (No. 200) Sieve in
m
Mineral Aggregates by Washing
E 11
--- Wire ---Cloth Sieves for Testing Purposes
(Application for copies should be addressed to ASTM, 1916 Race Street, Philadelphia,
PA 19103---1187.)
(Non ---G overnment standards and other publications are normally available from the organizations
that prepare or distribute the documents. These documents also may be available in or through li-
braries or other informational services.)
2.3 Order of precedence. In the event of a conflict between the text of this document and the
references cited herein, the text of this document takes precedence. Nothing in this document, howev-
er, supersedes applicable laws and regulations unless a specific exemption has been obtained.
3. REQUIREMENTS
3.1 Physical characteristics. E ach class of red phosphorus shall conform to the applicable
chemical and physical characteristics of table I when tested as specified therein. Class 3 red
phosphorus shall be coated with lubricating oil conforming to the chemical and physical
characteristics of table II when tested as specified therein. Class 4 hydrophilic dust suppressant shall
be a straight chain, primary aliphatic alcohol alkoxylate added during manufacture prior to drying;
the contractor shall certify that this requirement has been met (see 6.3).
3.2 Material Safety Data Sheets. Ma te ria l Sa fe ty D a ta She e ts for re d phosphorus sha ll be
pre pa re d a nd submitte d by the contra ctor in a ccorda nce with F E D --- STD --- 313 (se e 6.4).
3
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business